Deployment procedures | FortiSwitch 7.6.0 | Fortinet Document Library
Use the following procedure to deploy the entire topology from the FortiGate switch controller without the need for direct console access to the FortiSwitch units.
Related Topics:
Dualcore Switch Deployment Mode
Configuring NE Management (Dual Border Nodes, Access Switches
In this example, VLAN-based Spanning Tree (VBST) needs to be enabled on all devices on the network, VBST priorities must be configured for the core and aggregation switches, and wired and wireless
FortiSwitchOS Large Campus Switching Deployment Guide
The deployment guide provides the design and deployment steps involved in deploying a specific architecture. Readers should first evaluate their environment to determine whether the architecture
High Availability Configuration Guide, Cisco IOS XE
By default in standalone mode, the switches are identified as Switch 1 unless explicitly changed to some other switch number. During the conversion to
High Availability Configuration Guide, Cisco IOS XE Dublin 17.10.x
By default in standalone mode, the switches are identified as Switch 1 unless explicitly changed to some other switch number. During the conversion to StackWise Virtual, the switch
Technical Tip: High Availability basic deployment design
In the following scenarios, FortiGate is connected to two switches without LACP and with LACP (802.3ad) design. Any HA deployment is highly dependent on the network side.
Core layer | FortiSwitch 7.4.0 | Fortinet Document Library
With the use of a core layer, each aggregation switch only needs 2x100-GbE links, and the core layer is the only place where you need large numbers of 100-GbE ports.
MDS 9000 Switch and McData Dual Core Topology
This chapter describes how to set up a basic dual-core topology with an MDS 9000 switch configured for interop mode 1 and a McData 6064 switch. Devices are
Meraki Campus LAN; Planning, Design Guidelines and Best Practices
For Dynamic IP assignment, make sure the upstream switch port has the correct native VLAN settings. For Static IP assignment, make sure the chosen VLAN is allowed on the upstream switch port. Use
Multiple FortiSwitches managed via hardware/software switch
This example provides a recommended configuration of FortiLink where multiple FortiSwitches are managed by a standalone FortiGate as switch controller via hardware or software switch interface;
MDS 9000 Switch and McData Dual Core Topology (Interop Mode 1)
This chapter describes how to set up a basic dual-core topology with an MDS 9000 switch configured for interop mode 1 and a McData 6064 switch. Devices are connected to both core switches and all