Troubleshoot Common SD-WAN Control and Data Plane Issues
This document describes how to start troubleshooting common Software Defined Wide Area Network (SD-WAN) control and data plane issues.
Related Topics:
Latvia Debugs Sdwan Device
Troubleshooting SD-WAN with Kernel Debug
How to run the full kernel debug on an SD-WAN Security Gateway?
Troubleshoot SD-WAN Control Connections
When you troubleshoot such a problem, ensure that the correct serial number and device model was configured and provisioned on the PnP portal (software.cisco ) and vManage.
SD-WAN related diagnose commands
This topic lists the SD-WAN related diagnose commands and related output. When SD-WAN load-balance mode is source-ip-based / source-dest-ip-based. When SD-WAN load-balance mode is
Please read
What would be the the difference between router running in controler mode (SD-WAN) vs autonomous mode (“normal” IOS-XE”) because configuration mentioned before supposed to work?
SD-WAN Troubleshooting and Diagnostics
Users experiencing device connectivity issues at the branch site at a specific location, can select the device and specify an IP address to test the network connectivity.
Top 7 SD-WAN Challenges: SD-WAN Risks, Issues, & Solutions
The problems with SD-WAN include security challenges arising from its distributed traffic, difficulties in maintaining comprehensive network visibility, and the intricate process of troubleshooting, which can
Replace an SD-WAN Device
An SD-WAN device can fail or malfunction for a number of reasons, such as a device chip failure, device misconfiguration, or from daily wear and tear. If the SD-WAN device is unusable due
Technical Tip: Configure and diagnostic commands to check the
Configure the two WAN interfaces as members of an SD-WAN configuration. Configure a performance SLA that is used to check which link is the best to use. Create a static default route
Activate Debugs in vManage
This video provides the steps to activate debugs in vManage SD-WAN controller. Tags: sdwan, vmanage