AAU5613 Installation Guide (02) (PDF)
The guide specifies routing power cables according to engineering design documents, replacing cables when they are too short rather than splicing, ensuring grounding without solder joints, and separating
Related Topics:
Optical Cable Routing Diagram
Connecting the RRU AAU Optical Cable
Field optical cables meet these requirements well, so field optical cables are widely used for connection between base station BBU/DU and RRU/AAU. The connection between the antenna
AAU3940 Installation Guide
AAU3940 Installation Guide: Detailed instructions for installing the AAU, cables, and auxiliary hardware. Includes checklists for hardware installation.
AAU5313 Installation Guide (03) (PDF)
During maintenance, the power-off time of an AAU cannot exceed 24 hours. After the AAU is powered on and starts working, the personnel must keep a distance from the front of the AAU. The distance
AAU5636 (2300-2600 MHz) Installation Guide (03) (PDF)-En
The process of installing cables includes installing an AAU PGND cable, installing a power cable, and installing a CPRI optical fiber. The operations must be implemented in sequence.
AAU5310 | PDF | Electrical Connector | Antenna (Radio)
Installing CPRI Fiber Optic Cables optical modules are used Step 1 Connect the end labeled 1A and 1B on the fiber optic cable to the optical module on the AAU side, as shown in the following figure. Step
General Cable Operation Guide
This document describes the specifications for preparing, routing, and bundling cables and attaching labels to these cables.
AAU5636 (2300-2600 MHZ) Installation Guide (03) (PDF)
installing an AAU onto a tower and a rooftop. This section describes the procedures and precautions for installing cables. downtilt of an AAU. This chapter describes the checklist for AAU hardware
AAU5310 Installation Guide: Massive MIMO Setup
Determine the length of each cable segment based on the cable diagram inside the cabling cavity.
Draw a picture to summarize the wiring relationship between AAU,
After transmitting through the optical fiber, the receiving end converts the optical signal into an electrical signal, usually in pairs, such as one in AAU and one in BBU, as shown below.