Related Topics:
-
-
Do jumper fiber and pigtail fiber contain fibers
The main difference between these two cables is that the pigtail is terminated with a connector on one end and bare fiber on the other, while the jumper is terminated with both ends. Let's take a more detailed look at how these assemblies are used and how to differentiate. Because there are many types of fiber jumpers and fiber pigtails, many friends often cannot distinguish between fiber jumpers and fiber pigtails. The connector end is polished and tested under factory conditions, ensuring low insertion loss and high return loss. Optical Fiber Jumper: also known as optical fiber connector, both ends have connectors. Similar to coaxial cable, but without mesh shielding, for jumper. Fiber optic pigtails and fiber jumpers are different fiber optic products. -
-
-
-
How to repair ST interface tripping
Check how frequently TCNs are being generated, correlate them with interface error counters (make sure there are no full duplex/half duplex mismatches etc. ) and start to introduce different STP guards as required. When you are dealing with spanning tree it's best to draw a small picture of the network and write down the interface roles for each switch (designated, non-designated/alternate or blocked). Because STP loops can bring down an entire network, it is important to understand exactly what is happening and quickly implement an appropriate solution, as in most cases, all you might have is nothing more than a few minutes. Misconfigurations can lead to performance issues, network instability, and even outages. You can verify this using the “show spanning-tree”. Doesn't the trip unit tell you if it tripped on phase or ground? I'm not familiar with this particular trip unit, but normally, there are lights or targets to indicate cause of trip. -
-
-
